The Maggie is a high intensity magnetic separator with automatic purging capabilities. The Maggie is fitted in-line, using system pressure, requiring no additional pumps. Results in 1-5 micron capture rate.

The magnets are sealed in a thin walled stainless steel tube.

The magnetic tube contains several magnet/pole combinations. Each magnet/pole combination generates 9,000 Gauss on the tube’s surface. Magnetic tubes are then assembled into different sized separators to accommodate the flow rate/loading characteristics of the application. For example, a 12 core Maggie has over 80 magnet/poles, and a total magnetic surface area of over 250 sq. in. The ZGF design results in 80% better capture efficiency compared to magnetic drum separators.

While in ‘separation mode’ the particles are held on the outside of the magnetic tube, below the separator plate. Particles are allowed to accumulate on the outside of the tube. Tests have shown that the debris can increase to ½” thick. The Maggie magnets are 10X more powerful than ceramic.

Purging ‘Maggie’ requires no mechanical moving parts.

Fitted on the outlet of the separator is a valve arrangement, which during purge will shut the discharge and open the flush port.

The magnets are then shuttled within the tube, above the separator plate. Flow from the top of the separator flushes debris to waste. This process takes approximately 5 seconds. See DRY MAG for futhur waste processing solutions.

The DRY MAG